Tilt Switch on 1999 Bay Hawk

[cuellaraj]

I have a 2004 115hp. I need to remove the tilt switch to see if it is any good. I tried the switches on the outside of the motor and the tilt works. To my surprise because I did not know they were there. The switch is on the side of the shift/throttle. I could not remove a cover that covers controls I guess and where the ignition switch is. It is a Bay Hawk boat, 1999. Need Help.

[boats.net]

If have the side mount control box then will need to remove box from boat and remove handle from control box to get to screws holding cover on.

[cuellaraj]

Thanks. Do I have to remove the ignition first. The cover does not have any screws only the base which I removed screws but did not budge,

[cuellaraj]

BRP Switch

I just noticed that on the side of the remote box is a round cap with BRP on it. I remember pressing it back then. Does this have anything to do with controlling the tilt switch.

[boats.net]

Pop rubber plug out to see if has screws behind it.

[cuellaraj]

I will see it tomorrow. just came in. All I remember seeing was rectangle plastic plate below the ignition switch. I will pry it out.... Hope I don't break it. Thanks will let u know how it goes.

[cuellaraj]

Was able to remove it.. Removed the Rectangle plate. Did not attempt to remove switch because the wire is rolled around the lever and it I take it apart it might be spring loaded causing a big mess. Do you think it will be spring loaded?

[boats.net]

No it's not spring loaded just coiled so lever can move without pulling wire tight.

[cuellaraj]

Follow-up on Power Trim

It still did not work with new switch. Now I'm thinking it might be the trim sending unit. Could this be a possible problem? I hate to buy it at 92.00 and not be it. Open for any help. Thanks

[cuellaraj]

Open to any help. PlSSSSSSe.