If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a J25RESB Outboard. I just replaced the starter pawls and all the appropriate hardware but I can't get the pull rope to rewind. I get one pull then I have to take the entire pull start assembly off and rewind it by hand. Any suggestions?
Be sure that the tips of the rewind spring are hooked, when you install the rope before installing the handle, spin the starter pulley so there is existing resistance on the rope. Then finish your install.
Tweet
Comment