Buy Johnson Outboard Parts

Announcement

Collapse
No announcement yet.

Hi all

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Hi all

    Hi everyone. Glad to be part of the forum. I will get straight to my question. I have acquired a 1951 tn 27, I need to rebuild the starter recoil assembly everywhere I look I can not find an assembly like this one it has the 3 dogs attached to a center ring with three springs. Can anyone direct me to a diagram and or parts source for that type of recoil. All the ones I've seen have a metal plate with fingers on the recoil that contact dogs on the flywheel ( the reverse of what I have). My flywheel has the point setting hole in it. Any help would be appreciated
    Tags: None
  • #2
    What, in particular do you need to know about that manual starter?

    Comment

    • #3
      Well I've taken it apart briefly just to see what it looked like, the three springs that attach the dogs to the center are all different sizes. So I would need part number for the three springs. Then there is the part the three springs attach to, there is a spring under that. I'm assuming that spring put tension to pull the dogs I need that spring as it's sheered in two.

      Side question, could I replace the 3 springs with metal rods for better mechanical operation?

      A parts diagram or full manual for a tn 27 would help, as I could see if any washers are missing in the assembly also.

      Comment

      • #4
        After searching a bit more someone on eBay has a listing for one for $125.00 I'm not paying that when a few springs would probably cost around 5 bucks here's what I'm looking at that I need the parts for:.

        The picture is from the eBay listing, I need the three dog springs and I guess it's the "cam" spring under the cam the dogs attach to
        Last edited by 1951SeaHorseTN27; 08-04-2017, 11:35 AM.

        Comment

        • #5
          TN27 = 1950/51 5hp Johnson

          If the pulley turns with that retaining screw tightened (from what I see), nothing is missing.

          The special springs must absolutely be used as does the larger friction spring.

          Small springs 202155 - $18.96ea as of 2010

          Friction spring 302222 - $14.75 - as of 1992

          I have a few of each left in my remaining stock... If you're in the states, make a reasonable offer if interested.

          Comment

          Previous template Next
          Working...
          X