Buy Johnson Outboard Parts

Announcement

Collapse
No announcement yet.

1999 Johnson 25HP Idle Issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1999 Johnson 25HP Idle Issue

    Hi - My 1999 25HP Johnson (2-cylinder) was bogging down under power (half throttle or above) so I cleaned out the carb, twice, and voila, now it runs smooth. Mission accomplished - almost.

    Now it is idling rough, and sputters and dies if left unattended at minimum throttle. A little gas or a squirt from the choke will revive it. Anything above minimum throttle and she runs great.

    What did I do? Did I not put the carb back together right? Or do I need to adjust a low-speed jet or idle screw? Anyone know where it is on a 1999 25HP? I've managed to lose the manual and can't find a schematic online.

    Also, what about the idle adjustment knob on the tiller handle?

    Any advice would be much appreciated.

  • #2
    Could be bad nozzle gasket inside carb, low speed adjustment screw out of adjustment, bad intake gasket or linkage out of sync.
    Regards
    Boats.net
    Johnson Outboard Parts

    Comment


    • #3
      Thanks - any thoughts on where to find those adjustments, or an online schematic?

      Comment


      • #4
        Put it in water and adjust a 1/4 turn at a time to get to idle better.
        Regards
        Boats.net
        Johnson Outboard Parts

        Comment

        Working...
        X