Tweet
i just got this boat the flywheel was off as well as all the electronics under it trying to figure out wiring any help would be great also i went to pull lower end off and the driveshaft from motor will not lower through int case i can push up and down about 4 inches just will not come through what did i miss i have shifter linkage out also also have tilt issue goes down not up pump turns and binds down but motor just runs going up thanks charlie
-
-
Wiring is pretty straight forward, match all the colors and pigtails, be sure the pig tail colors match. The lower unit should just drop, may have some corrosion on the driveshaft. Make sure your Power trim is full of fluid, if it is then you may need to have valve body repaired, I recommend taking to a professional for this repair.
Comment