If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a 1995 Johnson 150hp Ocean Runner water is getting in lower unit oil. How do you re-seal or re-pack the lower unit to prevent water intrusion or oil leaking into water?
Pump gearcase lube into bottom drain screw until oil runs out the top vent screw hole, allow to sit for a few minutes to allow any air in oil to work out and pump more oil into gearcase then replace top screw first.
Tweet
Comment