J28esledr problem

[buttonpusher]

Last year the outboard was repaired, cleaned and running. This spring when putting in the pontoon the outboard stopped taking the pontoon to the dock. The outboard only ran a few 100 yards.

At the dock the outboard flywheel would not turn. I got the flywheel to turn but broke the bolt I placed in flywheel hole. Mistake; I tried starting the outboard and the bolt piece fall into the inside.

I pulled the flywheel. I saw that the throttle pin had broken. The sensor assembly had been rubbed open and the charge coil assembly had a wire broken from the bolt piece.

I got new parts. But now when I start the outboard there is a rattle under the motor area and stalls when put into gear.

I have this fall checked the lower gear shaft and see not problems.

Do you have any ideas on what is wrong?

[boats.net]

It sound like you may have bad bearings in the motor. This would cause the motor to seize or run very poorly while making much noise. I recommend taking to an authorized dealer for proper diagnose.

[buttonpusher]

Thanks

Thanks for your reply.